zc swap

[zephon96]

can anyone tell me where the location of the air idle control screw is on a ZC swapped motor? its in my 87 teg. not sure whether its location is underneath or on the side. thanx. --Jim

 

[cheese9988]

Sure can. If you lift up the throttle control from ontop of the intake (where the gas cable attaches to), you will see a tiny little screw. Underneath the plate its attached to there is a nut you have to loosen to make the screw move, adjust it where you need it and tighted the nut back down. Hope thats what you need.

 

[zephon96]

Originally posted by cheese9988@Jun 16 2005, 01:59 PM
Sure can. If you lift up the throttle control from ontop of the intake (where the gas cable attaches to), you will see a tiny little screw. Underneath the plate its attached to there is a nut you have to loosen to make the screw move, adjust it where you need it and tighted the nut back down. Hope thats what you need.

[post=512989]Quoted post[/post]​

I belive that'll do. thank you kindly.