Is the 90 integra same as 92? My friend wants to swap the b18b1 engine into a 92. I got the engine out of a 95 Teg LS. I have the axels, harness, axels from the 95. If its the same as the 90 then I know what I need. If not, then what would I need?
Well the idle happens every now and then, not always...so thats not a big concern to me. If it was revving up too high yeah but its only alittle.
Unfortunally I dont have the code reader, I would have to go to a shop and pay to get a read. Im not sure but it might be because on the headers that...
OBD2 ECU OBD2 Motor on 95 Civic Dx. I did the entire swap already.
I got everything in there. I dont know for what reason the starter went bad during the swap. That wouldnt let me start the car.
But i got a new starter and ran only vtec solenoid and vtec pressure and the car is working fine...
Im using a GSR OBD 2 from a 99. I just found out today that the alternator plug was different, luckly i had a harness from a 95 ls and switched the plugs.
Now I was told that my car would start without the Vtec wires hooked up, vtec is optional. But I plugged must and i couldnt get it to start...
Hey guys, So far my swap has been a headache. Right now im stock at the end of the swap. I was told my car wouldnt start without me wiring the vtec. I was also told that Vtec is optional. Have not checked if its true or not. Will be checking tomorrow. Now, I need help with some stupid things...
Hey guys, So far my swap has been a headache. Right now im stock at the end of the swap. I was told my car wouldnt start without me wiring the vtec. Have not checked if its true or not. Will be checking tomorrow. Now, I need help with some stupid things such as wiring the vtec.
I already know...
bump...
I got the ECU Diagram, the color code for the wires, But!!! I need the diagrams for the gsr obd2 harness. I need to make sure that im doing it right since im no mechanic, I dont know where all the sensors and switches on the engine are.
Ok I got all the info about the pinning out stuff. Vtec!
Vtec!
Question, Does anyone know of a good place to buy the materials? Color cables to try and keep it original. Also Whats the name of the small clamps/clips you attach to the cables to hook it up to the ECU harness??? It would help a lot...
Im selling a b18b1 engine, that I purchased to swap into a civic. But got a better deal on a b18c1 So I'm selling this one for whatever I can get.
I took it out my self from a guys' integra that was missing the rear end (wrecked).
It runs great, I did all the testing I could before pulling it...
Im working on the same swap, but i wasnt lucky enough because I have a DX, i need to wire up the vtec witch sounds like a b@#$@ch. I also for the budget have a LS tranny.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.