Recent content by DeCoY

Thnx bone, I am now being told that converting the wiring in my civic to work with the obd2 Ecu and all engine componants will be nearly immpossible. Now I am being told i will need to convert to OBD1 wich basically means i will need a new Distributor, ECU, injectors and god knows what else...

Can anyone tell me what subharness i need and where to find it ? or if fabricating wouldnt be too hard? Also, what does "IAB" mean? thnx

I did not get a sub harness, where should i get one? or would it be easyer to just fab it?

I got the harness from http://www.vtecfrog.com/Web_Pages/Prices.html It's the OBD0 chassis to OBD2a ecu harness. I am running all OBD 2 including injectors and using the OBD2 ECU that came with the motor (p72).

My 1990 civic Si now has my JDM - GSR 94-01 OBD2 motor installed and all that is left is the wireing. I'm using the p72 ECU that came with the motor and purchased a OBD0 chassis to OBD2 ECU conversion jumper. Other than the vtec wiring, what other wireing will be nessicary? Can I still use most...

Im using the hydro tranny with a conversion kit. Its like a bracket that bolts to the tranny and supposedly allows use of the clutch cable. hope it works.

are u positive they wont work? yes the swap is 96-01 but the axles appear to fit without too much bind... is there another reason why they wont work? thanks... And if ur sure these wont work, could i use my original axles? it was a 90 si 1.6.

I'm putting a JDM B18C (gsr) motor into my 1990 Honda civic (hatch) EF. the motor is between 92-2001 and is OBD2, will the axles that came with it fit into my car? thank you

so i just need to find a 90-93 integra and take that post mount off ? i think im gonna head to the junk yards today.

my gsr (JDM B18C) motor is almost completly ready to be swapped into my 90 civic si (hatch). I have a Mount kit that apperently needs a post mount on the timing belt side from a 90 integra LS in order to work. I am having a hard time finding this part... are there any alternatives ? Any ideas...

if i got an intake for a crx/90 civic would it be big enough for the gsr ?

I'm putting a JDM B18C (GSR) Motor into my 1990 Honda civic SI (hatch). I'm looking for a short ram air intake. The problem is, i dont know if a standard gsr short ram will fit in my small car. and the AEM Custom intake for this swap is over 200 dollars. Anyone know if a regular short ram for...

Im putting a b18c gsr motor in my 1990 civic hatch, if i go with a gsr header will that fit in my car? it looks crammed already with a stock d16 in it. I'm going to go with full 2.5 inch exhaust so any advice would be welcomed. thx

anyone else have any inpot ? thanx mucho brian im so stoked about this

I am putting a b18c GSR motor in my 1990 honda civic SI, The motor is 96+ and comes with a HYDRAULIC tranny, will this mount kit work with my CABLE clutch using this transmission? if not, what else will i need?