Recent content by efnastytime

  1. E

    boring ls block question

    ok i got a b18b1 block i am buildign for ls vtec wats the most ican bore it out since its stock bore is 81mm and wat type of pistons and compression should i run for a all motor and sumtimes nos set up since the b16 head will raise the compression???
  2. E

    Need Cel Help Asap

    OK I GOT A 90 CRX SI HAS OBD1 ECU AND DIZZY JUMPER HARNESS I'M RUNNING A JDM B16a I'M THROWING A NUMBER 9 WHICH ISA CYCLINDER POSTION SENSOR AND A NUMBER 41 WHICH IS A O2 PRIMARY HEATER SENSOR HOW DO I GET RID OF THESE??
  3. E

    crx injectors wont spary

    no the box is good but the injectors arent gettign power how do i get power to them
  4. E

    gas problem need help asap

    yea itsa a one plud in resistor box but if unplug it u can see the pins i ment only one pin is getting power but the injectors arent sparyin i am usign the si harness on the b16a i havent cut or changed anything
  5. E

    gas problem need help asap

    ok injecors are not gettign no power but the ristor box has one plug that has power how can i fix this??
  6. E

    gas problem need help asap

    ok injecors are not gettign no power but the ristor box has one plug that has power how can i fix this??
  7. E

    crx injectors wont spary

    ok injecors are not gettign no power but the ristor box has one plug that has power how can i fix this??
  8. E

    gas problem need help asap

    ok my crx has a obdo to obd1 ecu jumper harness and i got obdo injectoirs with a resistor box can any pls help me out could this be my problem??
  9. E

    gas problem need help asap

    ok my crx has a obdo to obd1 ecu jumper harness and i got obdo injectoirs with a resistor box can any pls help me out could this be my problem??
  10. E

    crx injectors wont spary

    ok my crx has the obd0 to obd1 ecu jumper harness wat do i need to do b/c i got obd0 injectors could this be the problem and also i got a resistor box any help from anyone???
  11. E

    crx injectors wont spary

    yes i tryed to satRT IT NOTHIN happens
  12. E

    gas problem need help asap

    idk how doi i check that?
  13. E

    crx injectors wont spary

    yes they were working b4 and i havent checked if there getting power do i take the clips of to do that or wat??
  14. E

    gas problem need help asap

    yes fuel pump turns on asndfuel rail fills up and it has 44 psi of fuel by my gauge
  15. E

    crx injectors wont spary

    i go ta crx si i just put a b16a in it the fuel rail is gettign gas but the injectors wont spary at all i took the rail off and turned the key and fuel pump comes on and fpr gauage reads 44psi but the injectors dont spary can anyone help me out
See more
Back
Top