Recent content by goose2

well i swaped out the solenoid and it still wont come out of park.both wires have power that go to it.i even swaped ecu's from a pg7 to a pr4.still wont come out of park.

it ts an automatic with an auto ecu.when i first put the ecu in the soleniod was disconected and i connected it later.i disconected my battery for 30 min to reset the ecu and the shifter still won't move.it was working fine b4 i disconected it.

i have a code 19 on my ecu.lock up control solenoid valve.what is this?

i just need an ecu to run a sohc zc automatic in a crx dx.i cannot find a pm7 automatic anywhere.

ok i bought a pg7 ecu and it runs great.but my automatic shifter still will not go out of park.and the ecu is blinking 19 times.lock up control solenoid valve a/b (a/t)

anyone know who is good at reworking an ecu?

as it says looking for a pm7 for a automatic tranny.

up

more power.besides the pm6 and pm7 are impossible to find in automatic. i was told that the pr4 ecu would work for my application.was i told wrong?

so the PG7 : 86-89 Integra (86-87 vac advance, 88-89 electronic advance) will work in a 91?wouldn't the PR4 : 90-91 Integra LS/GS be just as good?

its a sohc.and i changed my square dx harness into a round si harness.5 to 7 with the 2 new wires from the ecu.i just need to find an automatic tranny ecu.a pm6,pr4 ect.obdo.

swap ecu.if wireing is correct.

what is the best ecu for a zc sohc swap in a crx?pr4,pm6,pm7?

as it says i need a obdo pm6 ecu for an automatic transmision.just did a sohc zc swap in a crx.thanks

the ecu i have is #37820-ps9-a50.what # would i need for an automatic?