Recent content by haloae

ok i have a jdm gsr in my crx running off a p72. it is lacking power and the only code i have is 23 knock sensor. in low rpms when you give it a bit of gas it stalls till around 3000 vtec kicks in right at 4500 and i can see iab open when i rev it from under the hood and its runs smooth at idle...

does anyone have a how to on how to wire up a 93 integra cluster in a 88 crx or atleast a wiring diagram for the integra cluster so i could figuer it out on my own

i just bought a new dizzy for my car because i thought it was goin out but it ended up just being the wiring. i payed 180 for it and if i send it back im only going to get like 135. so if anyone wants it for around that price let me know trevor 217-898-8153

ok ill check it out they got some of them at the junkyard to

im putting a b18c in my crx and the drives side mount i got for the swap has two bolts and they are at an angle(see pic) but my motor has the mount from the newer teg with 3 bolts in a triangle type pattern. i tried just using the stock teg mount but the motor sits up just a tad and the bolt...

let me know what kind of hp #s you get

thats cool any advice on what size turbo would be good

yeah im about to put a b18c gsr into my crx and i was wondering if anyone has had luck with boosting a stock one. i know its high cr but im not lookin for lots of power just a lil boost to get an edge on the other swapped hondas in town. i have turboed a few D series and chipped and tuned the...

your prolly going to have problems with the front x member too

damn they sell for that much...i got a killer deal when i picked up my b18c with b16 tranny and ecu for only $500

yeah there is something wrong with the hinges and its not the best cf hood...and sorry about the size thats from like 3 months ago too he has done more work to it

my buddy did it and its a lil more work then just bolting stuff up....i dont know the details but i do know the fenders are half eg and half 2000

no it was me im just checkin cuz there are some older tegs in a local junkyard and it would be cool if they would work so i could save some money

ok im trying in find out what axles i need for a b18c with a b16 hydro tanny going into an 88 crx si. i have been told that 99-00 civic axles would work and they look right but i also read that 86 - 89 Integra axles will work. im just trying to figure this out be4 i go spending money and with...

locally and it looks clean as hell