Recent content by JODYG35950

:D :D :D THANKS for all the help, injector 1 was wired wrong and had a bad main relay. Thank you very much for the quick reply. Car runs great now!!

k, i'll double check all wiring with yours. Any answers on the fuel problem? This has confused me. The walbro pump is a 255 lph pump, also car has a adj. fuel reg. on it and fuel press. gauge. The gauge reads no more than 35 psi on rail.

I did a mpfi conversion on my 89 hatch dx, went by two different conversion how-to's to double check everything. Here is whats goin on that i have found: 1. when ignition is turned on, main relay chattered 2. fuel pump came on but didn't kick right back off after press. build-up(new Walbro) 3...

I have a friend with an 03 s2k. I have done a Comptech s/c, ecu fuel and timing piggyback, fpr, header, cat-back, and many other suspension and interior mods. Anyways, it still is a turd on low end until v-tec and s/c kick in at 6500 rpm's. Then you better hold on. It runs 13 flat 1/4's...

The main relay operates the fuel pump also!!

found out the iac plug was on the knock sensor. I changed it and extended the wires to work, now were do I wire the knock sensor to. Where can I find a pr4 pinout?

What's up guys, need help please. I put a B18A1 in and used my si harness on the motor. Everything plugs up except I have no IAC. Where do I need to wire this to on the ecu. Also, are there any other wiring conversions I need to do for the stock harness with new ecu. I couldn't find a thred...

Also, will stock rods handle the power of good cam and turbos. If so, about how many horses? P.S. Crane makes several cams for the D16A6

I have a d16A6 block with new rods and pistons bored 30 over. I have access to a Z6 head. Which will be better for a turbo in the future. I have heard many guys argue the point of non vtec being better because of tuning ease, but also all the major racers run vtec heads in their cars...

i have a friend with an 03 s2k. He turned a 13.3 with a comptech charger and centerforce dfx clutch. He was running street tires though and spinning through 3rd. I think anything lower than 14.1 for a stock car is unbelievable.

drill a small hole in the new cap close to where the old coild use to sit. Be sure to zip tie your wires away from the rotor button.

tap into the black/yellow wire outside the dizzy for your positive, then go inside and remove your stock coil and connect to the negative side wire (white I think) and run it outside through the cap and over to your new coil.

have you checked the fuse marked Alternator Solenoid Valve? this fuse controlled power to my pump and ecu in a 91 civic hatch.

OK guys, I have found a Z6 head to go on my block, how do I wire the dizzy to work with my factory wiring? 91 CRX HF is my car.

I Have maybe a dumb question, I have an 88 crx si d16 block that has been bored 30 over with new rods and pistons in it. I had planned to swap over my sohc head to that block and go with it, but I recently acquired a full D16a1 motor out of an 89 teg. Will the D16a1 dohc head bolt on to my...