Recent content by keg

its a obd2 harness in car i want to run 0bd1 ecu have swap harness but my ecu is different to normall obd2?

I have a ek civic with a d13b engine im wanting to switch to obd1 ecu so i got a swap harness but my ecu only has 2 plugs comming out of it, so the harness doesnt work the code is 37820-p2a-003 can any1 help?

chip your ecu

all good for some reaseon plugs where screwed replaced and now its all go:)

you cant get cam the wrond way one has slots one doesnt? tryed a dizzy that i new worked from a mates car still no go ? xs power cams used them before without probs

we changed cams in my b16a swap now wont start? timming is perfect along with cam timing the spark seems really weak and when you crank it over the rev counter jumps up and down? ran before we did the cam swap?:confused:

nope no plug we have looked everywhere with no luck

Hi im trying to do the timming on my mates 90 da integra, now i know that newer hondas you need to jump plug but do you for 90 integ if so where is it? because we have looked for hours but can not find?

i havnt even done drivers yet passenger side binds aswell

i had a look at the teg we took axels out of last night its a 89 b16a teg did they change them in 90 to 93?

so it just that spacer looking thing removed that but i think it still binds

just finishing of swap in my ef b16a and using 90 teg axles now when ive read remove dust cap where abouts are they and how are they removed and why do you remove them?

just found one what are the two hoses comming off it for?

Ive just swapped a b16a into my ef but the ef was a cable speedo and the swap was electronic can anyone help how do i get around this?

it sure is i swaped from zc to b16a