Recent content by kelbizzle

I dont believe so. Mine is bad. It only throws error code 6 and I beleive it's only when I startup and drive away without letting it warm. mine backfires a lil and gargles a bit. But that could be because my cat is disconnected from the resonator :-D hehe

Thanks guys I think I'm gonna go with your advice. I'm going to get the jdm conversion. If I had the loot I would get the other one. One good thing about the jdm is replaces a messed up spot in my fender from my wheel falling off. Hey anyone even seen those M3 or Z3 sport with the...

I was wondering what kind of modifications you would need to make for this to work and look GOOD. Also anyone ever seen it with TL headl lights or are they the same thing. They look different. I still might go for the JDM conversion for my teggy. But money is the issue.

If the wires are broken...Could I get wires ordered or would I have to cut them out of another integra.

Anything else I need to know before changing out the sensor?

I was just curious. My check engine light recently came on and I did the whole jumping the service connector. Only to find out it was the ECT sensor or circuit. I was just curious if this was something I should replace and repair immediately or could it wait until next week. I was also...

You dont wanna know. My cat was so clogged that thing finally blew out. So it sounds like a john deere on roids. I still Have the bogging. I havnt done anything with it. I'll have to wait until next week. I'll def keep everyone updated.

oh ok I think I could probably do it. I have the haynes manual that thing is handy. :laugh:

Now has anyone done this? Is it hard to do or should I just pay a shop?

Wher can I find the jdm front end

http://www.ridejudge.com/featured/0202/Current3.jpg <~~This is what I want. Have you ever seen it? You know where I could get it done.

My lug nuts were loose for days. I got so many mechanics opinion on what the noise was. None of them guessed it wouldhave been my lugnuts or else I wouldnt be here today asking for help. So could anyone please tell me how to remove the wheel studs. Two of mine are bent and also should I replace...

I put some Gumout in it. It fixed the idle thing. I dont really notice a difference in the hesitation. It's going to goto GW on sat. I'm sure they"ll figure it out. I hope

Thanks. These are all good Ideas. I'm really excited. I will def. Try these out tomorrow. And for those of you that are all interested. I will post a reply. Thanks again people.

I'll do that also tomorrow.