Recent content by LtWilliamT

I have a 91 accord DX with auto tranny. The reverse gear blew out, so i did a tranny swap with the same type (with low milage). When i got done, i went to drive it and it wont stay in gear. It would drive fine for awhile, then it just wouldnt go anywhere. I did 3-4 fluid flushes (magnit had a...

Check the coolant. Also check ur IAC valve located on the back of the intake. These are know to clog up and cause this problem....i have to clean my bros in in civic tomorrow haha.

I have a F22A4 from an early 90s accord that i bought for $75 as a back up for my accord. I have a friend with a 94 accord with a blown motor. I was wondering if i could swap it in. What would i need to do this? Im pretty handy with hondas (just finished my bros D16z6 civic swap on monday :p)...

I checked the plugs, they are wet but the gaps are dry, so they must be firing?

ok, i got a Chiltons manual from the library, and if im reading the diagram correct, the kid screwed up the order. I changed it to the one in the book and its firing like its about to catch and run, but its just not starting......its soo close

I have no clue if the fireing is correct, i know the wires from the dizzy to the sparks are correct..... I took his word on the new engine and dizzy.....I know the battery is crap, but i was using another car to jump it. It grinds like it wants to start, it gives what sounds to be like 3 fires...

I just got this 94 Del Sol from this kid down the road. He said when he bought it the engine was just replaced with one that had only 80K on it. He was sold it to me for $500 cause the timing was off and need to be fixed (didnt run :(.... Me and my friend last night did the timing belt and water...

I'm reviving my old thread, cause it still wont start. Ive taken the line off my the fuel filter and i was gushing out gas. I put 5gals of premium in and some sea foam. Replaced the sparks and wires................still nothing. Im seeing some dampnedd on top of tranny and where the tranny and...

you can hear the pump come on, and when we took out the plug it was covered with gas.

we pulled out a spark plug and cranked it and my dad said he saw a spark

Ok heres the story. Back in August my dads Civic broke around the cat and we had no time to fix it so we let it sit till Jan. When we fixed the cat, we tryed starting it and it wouldnt. We have sence changed the battery, starter, and got a dizzy from a junkyard that looks newer, but who really...

i was just found out that he got the car checked by a technician and he is saying its a lose rod bearing......should i just change the rod and bearings?

thanks guys.......this means i need to pull the engine and replace all of the seals right? this is gonna be a real J.O.B.....well im willing to learn

Im about to get a 1995 Acura Integra GSR with the B18C1 motor that just had head work done......It ran great but now i was told one the piston rods are bent. I was thinking bout just goin through the oil pan and replaceing the crank shaft, bearings, and using performance rods, pistons, and...

it is OBD0.......the ECU is too old to chip......is there a ECU that i can chip, tune, and plug into my crx?