Recent content by PowerAddict

  1. P

    oh man. Need help quick!

    thanks anyway everyone.
  2. P

    oh man. Need help quick!

    100% on the fuel. I just pulled the trannny. someone helped me get it started...don't really know 100% what was wrong, they say "flooded" who knows.
  3. P

    where is the underdash fuse box.

    on a 98 honda accord where is this mysterious under dash fuse box. I found 3 relays on the back side of the passenger side fuse panel by taking out the glove box. But alldata says there's an under dash And I've found the a/c condenser, blower motor, and PCM????
  4. P

    oh man. Need help quick!

    clutch pedal has to be fully down for the clutch safety switch to allow the starter solenoid to get power. thanks you though.
  5. P

    oh man. Need help quick!

    well, its not the mobilzer. I am stuck. any ideas?
  6. P

    oh man. Need help quick!

    I'll look for that, I don't recall taking one off, thus I don't remember putting one back on, so thats a possibility. thanks for the suggestion.
  7. P

    oh man. Need help quick!

    have spark, and fuel pump is turning on. Cant find the schrader valve to look for line pressure. I had the door unlocked, while the battery was out, and put the battery back in with the door unlocked. then I opened the door, and put in the radio code. Did i mess with the anti-theft? Is...
  8. P

    oh man. Need help quick!

    okay...it is turning over. Just no start. Still have to see if its spark or fuel. any thing I could have forgotten to fasten or put on?
  9. P

    oh man. Need help quick!

    its all tight. Unless the bendix isn't pushing out far enough
  10. P

    oh man. Need help quick!

    So I got the clutch in, everything bolted, ready to go...or so I thought. I've never done a clutch in an accord before. I tried to start it, and it started for a second then died. Then When I tried to crank it over again, the starter is just spinning, not hitting the flywheel. what do I...
  11. P

    another question...sorry

    hmm, how do I unstake the nut?
  12. P

    another question...sorry

    Well, I'm trying to put the ball joint back in the lower control arm, and I'm having difficutly. It looks like the axle shaft is all the way in, the WSS is lined up with the teeth on the axle. and I put the impact on the axle nut. Any suggestions? I've taken axles out numerous times before...
  13. P

    where to add trans fluid

    where are those in relation to the transmission in the vehicle. I see a plug on the bottom below the axle shaft on the passneger side with a 3/8'' drive, and I see a larger plug right by the fender well with a 1/2" drive.
  14. P

    where to add trans fluid

    I lost my alldata info, I see a few places it looks like you can put it, but where do I add tranny fluid to the 5-speed?
  15. P

    how to hold flywheel w/o the tool?

    good suggestions guys, thanks!
Back
Top