Recent content by r6_sivik

i did the same thing you said about going to my old tranny and i replaced all the seals and there still dripping but not as much on the passenger side shaft it doesnt seem o go in all the way there is still about 1/4 of an inch to go is it to short do i have the right shafts the shaft i have are...

i just finished my swap(gsr into del sol with b16 tranny) i look under neath the car and theres a puddle its coming from the tranny how hard is it to replace all the seals on a tranny i already replaced the seals on the cv joints where else could it be leaking from the drain plug and fluid check...

just found out they told me it depends on which computer ur running ur better off buying a distributer and save the hassle of having to reprogram ur computerjust so you can repin ur dist.

what does ur drivers side mount look like on ur current motor?

you need the 2000 civic si ac bracket and the tensioner pulley

just found out it depends on which computer ur running if ur running a p28 you can program the computer for it if ur running a p30 no dice

bump i have the same problem

i need to know the same thing im stuck right know also anybody know how to

im dropping a gsr in a delsol i bought gsr shift linkage thinking it would fit guess what its not if i cut it will it shift properly people keep telling me differant i hear its fine others tell me it sucks whos done it and does it shift right??

want to buy del sol dohc vtec shift linkage help?

im selling a civic 2000 si shift linkage brand new in the bag paid 115 for it i just want 55$ plus whatever shipping is need to sell quick before i cut it and weld it

del sol dohc vtec shift linkage help

its for a del sol sorry about the lack of info can i weld my linkage shift that is?

so ur telling me that a 2000 civic si shift linkage wont fiton my gsr swap? is it to long or to short cause i just ordered one if it doesnt fit im just gonna cut it and weld it does anybody know?

how good will it run i know it wont open up the secondary butterflies so since its not going to operate them can i just remove it out of the manifold?