Recent content by shifter

nono. everything is hooked up. i am getting no cels. if i connect + from battery directly o vtec valve - it's works. i hooked 12v lamp inline on wire wich goes from ecu to vtec valve. it not light ether...

we have swaped in '94 civic coupe b16a engine. Stock engine was d15b7. stock p06 ecu i've swaped to p28 ecu. wrote p30 bin with switched of: knock sensor, VTP, injector test, eld and etc. wired wire from A4 ecu pin to a vtec solenoid. if i power it directly from battery + - vtec work, but ecu...

wich tranny fluid i have to use? i use 10w40 engine oil. may low oil level can cause such strange things with lsd? cos ther nothing any strange noises. when i changed oil after buing a tranny i got clean oil from tranny... and so on. and it rotate wheels.. but it's looking as it's slipping...

ah. thanks. i got an idea =)) but what about tranny? running engine is nothing without tranny =/

i thought that diffrence in pressure plates are only spings. in cable tranny they are softer then in hydro tranny. but everything else is same. but may be really i have just a slipping clutch 'cos it for b16a2 tranny actualy? i have a clutch and flywheel from b16a2.

i think i will do that cos i dont know what can cause that. i just hope that someone can help with that.

no. it;s a 92-93 integra xsi jdm tranny. it's a cable, but it uses hydro type clutch with bigger input shaft.

there no bar and i looked at photos in internet. it look like at photos. so i think it's defenatly lsd there. but something wrong. will 92+ b16a clutch work in YS1 tranny? i sisnt get any strange soud from a tranny when it moves. btw, when car jacked it's easy to spin left wheel than right...

have an eg civic with b16a sir 1 swap and YS1 tranny with lsd from integra XSi 92-93. first problem. i used obd-1 distributor with p28 ecu with p30 programm in it. and i am getting jumpi idle with eacv not plugged in and FIV removed. i closed idle srew fully and close throttle with my hand and...

he run auto p13 right now. and now he using a FMU. but FMU suck. and uberdata still not suppoer p13 =(

hm. i mean tranny control module for tcm.. he has no traction control. he usingsome jdm p13 ecu with 3 plugs

why i ask, 'cos i know his accord has TCM. and his tranny controlled by that tcm. not ecu

are you sure that this will work after that??

he wants a auto. =) p28... it's a auto p28 converted to a manual.

he searching h22 auto tranny. but right now he has a f22 auto tranny