Search results for query: *

Tuning question: At Vtec switch over are the low and high maps summed or does it switch from one map to the other?

I'm currently running 440's I need to upsize I'm looking at 880's my question is how large can I go and still get the engine to idle? Is anyone running 1000's or 1600's? Thanks for all the help!

I'm needing a LSD for my trans, anyone have one available? Thanks...

I'm in the process of doing a B16 swap and want a LSD for the trans. Will any B series LSD work?

I want to replace the bolts with some ARP's, are they 8mm or 9mm? Thanks....

Is anyone running 1000's and if you do run them can you get a decent idle with them?

I need to lower my boost, does anyone have any springs laying around? Which one's? Cheap? Thanks...

I am swapping in a B16A OBD0 with a YS-1 trans into a 91 civic si. I need a LSD being that I am running a turbo. Which one fits and which ones does anyone have experiance with and like?

Has anyone had an issue of blowing alot of oil out of the dizzy? I always seem to have some oil under the dizzy prior to the turbo but now it blows out. I replaced the "O" ring on the shaft but no luck. I don't seem to have any shaft play but there is oil inside. I don't want to replace it being...

Got a quick question; I have the five bolt output on the hot side and the five bolt output flange that you get your down pipe welded to, should I get a gasket to install between them? Are you all running gaskets there or do you just bolt the flange on? Thanks...

Hi eveyone, looking for some suggestions. I am installing a jdm B16A in my civic, I will be running a T3/T4 .5, .63 57 trim turbo. at 8 to 10 psi, I will not turn over 8200. From research I need to install ARP head studs and a new head gasket. What type of gasket (brand) should I get and should...

Hi everyone, I have a 91 Civic Si and I am swapping in a JDM B16A to replace the D16A6. If I don't want to use the stock manafold, what header will fit the engine and work in a 4th gen? Thanks...

WTB a D16 turbo manifold that will bolt to a T25 turbo, has to allow AC...

For all the real brains out there: I have a 91 Honda civic Si and want rear disk brakes, I have access to the complete setup from a 95 civic Ex ie lower arms, calipers, cables, brakes and such. Is there any way I can make this work on my car? I know about using Teg 90-93 parts but I can't...