has about 110000 on it and was a nice get around engine but i pulled it out last week so if anybody needs a motor and trans i would be willing to take 300 for it
comes with:
motor
engine
shift linkage
ecu
rear bracket
and drivers side axle
so.... if you would like a cheap motor setup get...
i have 1994 civic cx hatchback and wanted to do a d series swap probably a d16z6 with a si transmission and wanted to also turbo the motor. Would it make sense to build that motor or are they good for forced induction. Also what kind of times am i looking at if i do this. Not too sure what...
i have a 2000 civic ex with a jdm b18b1 in it with a type r trans in it. i have a few problems with it
1st: when the car goes past 3500 rpms the lights get brighter interior and exterior
2nd: is that my tach keeps on jumping around up and down
3rd: new battery just died
to my tach i have these...
i recently did a motor swap and have these parts from my d motor:
ac compressor
d series header
d series axles
d series motor mounts
d series transmission
Ac cooler and lines
b series vlave cover
d16y8 ecu 32820-p2p-a12
top half b series header
d series shift linkage
d series t bracket
d series...
i almost have all the codes cleared up. now i was looking at the throttle body and there is a port for a hose that is on top now my question is what is it and where does that hose go to? please get back to me soon thanks
i have a itr trans with a b18b and would like to get part numbers for clutch cover all bolts needed and the two mounts couldnt find it on acuraoemparts.com. Was just wondering if i could get some help with locating some part number thanks
ok after doing my first swap i had idleing problems. i found out that it was a vacuum leak it was the new throttle body gasket that i bought from honda. i made a new one and it runs fine now. my next question is what my speedometer doesnt work. i have it plugged in and the fuses are not blown...
Ok after doing my first motor swap in my 2000 ex that i put a b18b in i have a few questions. Got the wiring done but the engine that i bought had a 9 pin connector(jdm motor) and the civic one had 8 pin connector. So my question being is what is the blue wire for?
on the integra dizzy. Please...
Just wondering if i do a b18b swap. I want to boost it but that is besides the point. I was wondering I was searching around and I found a guy that said it was plug and play is this true. And is that obdII. What do i need for this swap does any body know a website that sells them for cheaper...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.