Search results for query: *

  1. M

    Poor throttle response / LOW rpm choking

    So the chip in my P28 must have gotten messed up. I replaced it w/ a stock JDM b16 chip, set the timing, and car runs perfect.
  2. M

    b18c swap

    Sorry, my answer was directed at the "complete engine, trans, ecu" packages. You are correct about the complete change overs.
  3. M

    b18c swap

    You'll still need motor mounts, shift linkage, axles, maybe a throttle cable. Also, since you have a 1998, you'll need to get a OBD2>OBD1 conversion, I think you can get those online for ~$100. Unless you are buying an obd2 engine, which most likely, you are not.
  4. M

    want to swap

    after buying mounts, shift linkage, and axles, you can do a fresh B16A swap (as suggested above) for about $2500. Probably your best move for the money.
  5. M

    Poor throttle response / LOW rpm choking

    What sensors? Dizzy cap / rotor look fine. Dizzy is less than 9months old. Bought some spark plugs today, should put them in later. Also, it idles fairly high. I tried adjusting the screw in the TB, and it still idles 1.2k, at the lowest. does the TPS tell the car when it's at idle / when it's not?
  6. M

    Poor throttle response / LOW rpm choking

    Hi, I have a 1989 CRX converted to OBD1, with a B16a. It has been my daily driver, but I recently developed this problem. When the car is cold, it doesn't have any problem. once it warms up, it gets poor throttle response (at idle, as well as driving), and when driving, if I slow down to...
  7. M

    Clutch/ flywheel help?

    Hi guys, I was wondering if anyone has had problems with putting a pressure plate on before? I've got the flywheel + clutch off of the motor, and the pressure plate cover won't sit down on the flywheel studs. There's like a 1/4" of space. If I take the clutch out, it sits fine. If I install it...
  8. M

    Low RPM choking problem. HELP.

    Tomorrow I'm going to clean out the intake manifold / IACV, and do a basic tune-up. I set ignition timing pretty recently, so I doubt it's that. Not sure about cam timing, it's all stock, unless I jumped tooth or something.
  9. M

    Low RPM choking problem. HELP.

    Hey, I have a b16 in a crx, and had been driving the current setup for about a year, with no problems. The issue I have now started suddenly, and I'm not sure what the deal is. My car drives fine when it's cold, but after 10 minutes of driving, the car will try to stall under acceleration...
  10. Try your Search on Google

Back
Top