Search results for query: *

The round plug on the drivers side goes into the resistor box...that little metal box under the hood hinge... if theres no box than it wasnt a si or it wasnt obd0 and you need to get one from an obd0 car.

I picked up mine for $350cdn!!! what a steal thats like $250us eh! BUT the punkass didnt tell me hes keeping the flywheel/clutch assembly i thought no big deal ill get ACT stuff. well im a real noob so I got :owned: I had to find out on my own that the alternator was shit, he kept the fuel rail...

your clutch wont work that must suck. the axles should be ok.

any updates?

? :spin:

The b18a swap in my 91 crx Si just wont ever get finished :unsure: Checked the timing it was WAY off I set it tdc on the cams and crank only, both cams arrows point stright up right? then replaced teh coil and ingnitor and cap with my known to work Si distributor...and still no sparky :( It...

I was just pulling on teh slack after that I pulled real hard :lol: and it went up some more disengaged the clutch, thatnks for trying to help. and the new clutch setup feels very nice and STIFF!

EUREKA! IM A NEWB! :lol: lol I tried pulling up on the old tranny lever it goes up easely then stops..so i give it a real hard tug and THEN I feel it release teh p.plate! i go to teh b18a lever... its VERY hard but there it goes! jeez sorry for wasting anyones time, I hooked up teh cable like...

well the clutch and release bearing are fine becuase they are all new, heres what i did, pulled out my sohc zc/si tranny...installed teh ACT flywheel, extremepressureplate and SS clutch disc all to torque spec (maybe a couple pnds over spec :roll: ).....attached teh trannycase to the...

Before dropping the motor I installed an act flywheel, clutch and pressure plate. As soon as I bolted the tranny and motor together i checked the release arm to see how stiff it will be... it seemed to be very easy to move. I compared to the zctranny I pulled out and they were similar so I...