Before dropping the motor I installed an act flywheel, clutch and pressure plate.
As soon as I bolted the tranny and motor together i checked the release arm to see how stiff it will be... it seemed to be very easy to move.
I compared to the zctranny I pulled out and they were similar so I figure everything is OK.
But now when I press the pedal it just plops down to the floor with very little effort, this is a extreme pressure plate so it should pretty damn stiff.
I have no idea what is going on please help.
As soon as I bolted the tranny and motor together i checked the release arm to see how stiff it will be... it seemed to be very easy to move.
I compared to the zctranny I pulled out and they were similar so I figure everything is OK.
But now when I press the pedal it just plops down to the floor with very little effort, this is a extreme pressure plate so it should pretty damn stiff.
I have no idea what is going on please help.