Search results

  1. S

    91 hatch need help please

    If you can't remember or don't know when your fuel filter was last changed, it's probably time for a new one. The limited flow allowed by an old fuel filter may be fine for the fuel demand at idle, but at higher RPMs, the fuel demand is too great, thus bogging down your engine.
  2. S

    DOHC ZC Timing Belt Issue

    Thank you, thank you THANK YOU!!! :thankyousigna2: I stopped short of sending you a PM, for fear of aggravating you. Now I can get tags on this bitch and drive it!
  3. S

    DOHC ZC Timing Belt Issue

    I have the correct belt. 14400-PK2-004. Timing is spot on. Purrs when running. My issue is with the close tolerance between the belt and the motor mount at the tensioner pulley. The last thing I want is for the belt to be shot to shit for coming into contact with the mount. What I need is...
  4. S

    WTB : HF tranny

    I was looking to make the trip in less than half a day, but if I have to, I will have one shipped.
  5. S

    WTB : HF tranny

    Anyone have an HF tranny near Cincinnati?
  6. S

    NEED tunes!!!!!

    Go here: Vehicle Wiring Database The 12 Volt ROCKS!
  7. S

    RWD hatch

    That's what I was afraid of. "Hey, look what I did" or "For Sale: Dead project" coming soon.
  8. S

    91 civic problems

    Check two additional things. For the dash lights, make sure the red/black wire has continuity from your light switch all the way to your radio. For the no start, check the clutch (MT) or neutral (AT) switch.
  9. S

    RWD hatch

    The one that I saw used a D- or B-series. What they did was one way or another put the front hubs on the rear so the stock drivetrain would remain intact. For all the engine knew, it was still pulling the car versus pushing it. Easier said than done, but all that needs to be done is cut the...
  10. S

    RWD hatch

    I saw that someone had done this somewhere, but I can't for the life of me remember where. Any ideas?
  11. S

    ECU, Good or Bad? How do I tell?

    I don't know how many times I have read it here in the last couple of years. Make sure you have an ECU from the same type trans you are goin to use!!!! Guess what... A/T ECU won't work with a manual trans. Sorry I wasted everyone's time.
  12. S

    ECU, Good or Bad? How do I tell?

    Don't know yet. I should have been more clear earlier. I am in the middle of an EF/D16Z6 swap with OBD conversion. I think I have taken the road less traveled in that I am using an entire wiring harness, minus the dash and rear harnesses, and am repinning those connectors so that it will...
  13. S

    ECU & Tach Signal

    I need to clarify myself before I am corrected. The RPM signal from the dist does not enter the ECU. I would imagine the ECU gets RPM input from the CKP or creates its own using output to the injectors.
  14. S

    ECU & Tach Signal

    I can't add the image, but the engine speed output signal (RPMs) does not enter the ECU at all. It leaves the Ignition Control Module in the distributor via a solid blue wire and from the splice goes to the tachometer, the cruise control box (if installed), and the tach test connector (white...
  15. S

    ECU, Good or Bad? How do I tell?

    I have a P28 and the car won't start. I have checked all four grounds and get 0 ohms resistance. I have 11.78v at the Blue/White (D1) and at both Yellow/Black (A25 & B1). As far as I know, this ECU is good. Someone please tell me I have something yet to check.
  16. S

    D16Z6 with OBD Conversion

    Many sleepless nights and painfully persistant migraine. Buy the damned Rywire conversion harness. That's all I have to say.
  17. S

    New to Datalogging

    So... an over-simplified version of the instructions would be something like this: chip the ECU, make the cable, download software, plug in and go?
  18. S

    New to Datalogging

    I have the laptop, I have the ECU, I have the engine. Beyond that, I am completely lost. Where do I find instructions to make the cable between the laptop and the ECU? Serial cable, right? What program do I use for the actual logging, and where can I find it?
  19. S

    one of my nuts hurts

    Forget reading four pages! 1. Have you had a vasectomy? If so, 2. Have you lifted, or attempted to lift, something very heavy? If so, then it will go away after about a week. I had that very thing happen to me about two months back. I was lifting a 250 lb. piece of granite bench seat...
  20. S

    My friend got MAD as hell yesterday

    I got ass until two weeks before delivery and then two weeks after.
  21. Try your Search on Google

Back
Top