1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

91 integra nightmare

Discussion in 'Integra' started by boostedteg91, Nov 11, 2009.

  1. boostedteg91

    boostedteg91 New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Nov 11, 2009
    ok here i go i have a 91 integra that im putting a d16y8 into. i already know what everybody is going to say WHY and my reason is the y8 is fully built and boosed. so now to my problem i have been going through 3 dizzys in one month. the dizzy im using is a obd1 and the ecu that im using is a chipped obd0. every time that i start the car i get a code 4, when i go and switch out the wires to see if they are in the wrong place and go to start the car it wont start. so i put the wires back where they were and now im getting 2 codes a code 4 and a code 8. did i just fry my dizzy. and also my other question is can i use a obd0 ecu and a obd1 dizzy? i need help asap im needing to get this car running by tomorrow. thanks
     
  2. boostedteg91

    boostedteg91 New Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Nov 11, 2009
    is there nobody out here that has an answer??
     
  3. SlushboxTeggy

    SlushboxTeggy It's only stupid if it doesn't work VIP

    Messages:
    9,392
    Likes Received:
    245
    Joined:
    Sep 14, 2004
    Location:
    New Jersey
    Dizzy and ECU should match. That may not be your only problem though.
     
Verification:
Draft saved Draft deleted

Share This Page