1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

B18c1

Discussion in 'HYBRID -> EG-EK / DC' started by turboteggy, May 5, 2007.

  1. turboteggy

    turboteggy New Member

    Messages:
    15
    Likes Received:
    0
    Joined:
    Apr 29, 2007
    What up!! B18c1 engine harness on the pass side shock tower connector C104 is a 2pin connector has a red wire and a yellow/black wire. Question is where do they go/ feed/ get fed from. this is the only harness connector in my bay that is not connected grounds are good everything else is fine my car dont crank must find out where these wires go.:confused: :mad: :(
     
  2. turboteggy

    turboteggy New Member

    Messages:
    15
    Likes Received:
    0
    Joined:
    Apr 29, 2007
    Im pretty sure all dc with a five speed have this 2 pin harness connector on the pass shock tower someone jus please take a look, especially if you have a b18c1. Could someone unplug this connector flash the ecu and tell me what the code is so i can figure it out for myself something andything:mad:
     
  3. slimtdx

    slimtdx New Member

    Messages:
    28
    Likes Received:
    0
    Joined:
    Apr 5, 2007
    that sounds like the IAB sensor, its just under the intake mani...
     
Verification:
Draft saved Draft deleted

Share This Page