Boost ready b18c longblock f/s

[b16ahybrid]

The block is fully built and ready for boost.
Golden eagle Sleeves (81.5mm bore)
Wiseco coated pistons (9.5:1)
Eagle rods.
The block was professionally asseblembled using ACL bearings ... Stock b18c head bolted to the block with Golden Eagle head studs and a factory acura head gasket, torqued down per G/E spec.
Brand new water pump and timing belt.
Comes with a Skunk2 intake manifold, dist,sensors,and MSD 6-AL ignition (wired into the wiring harness for a clean install)..
Parts alone have cost me about $2,400 without labor...(block alone)
Asking $2,400 for the complete long block...
Make me an offer within reason, I DONT have to sell, but would LIKE to sell the engine....
Thanks for taking your time to look.

Oh the motor has -0- miles on it, it's been fired up, ran for a few and then shut down....

Prior to head install
http://i78.photobucket.com/albums/j103/b16...engineblock.jpg

during head install
http://i78.photobucket.com/albums/j103/b16...id/100_0401.jpg
Can provide more pics upon request...

Located in Washington state.

 

[driver1]

ur pics are junk....they dont work

 

[HatchSpeeD]

Third times a charm

 

[pageusaf]

use imageshack

www.imageshack.us

never had a pic do that stupid photobucket shit

 

[b16ahybrid]

Thanks for the bumps, I couldn't get in yesterday to fix them. They now work.

 

[b16ahybrid]

Bump....
The motor is out of the car and ready for pick-up or drlivery...

 

[b16ahybrid]

bump