i have a 1992 dx sedan that has either a bad camshaft oror sheered pin. needing help. car will not get spark at all and rockers do not move. never faced this problem before. PLEASE HELP!!!
i'm not sure if the bottom end turns over or not but when i try to start it, it just makes a really loud spinning noise. like it's not catching anything..
ok so u need to go through pretty much the whole engine first take the cover off the top the belt of the cam and turn the cam gear will he rockers move? if so the top end is good otherwise some shit is broken down below and your going to have issues
i'm not sure if the bottom end turns over or not but when i try to start it, it just makes a really loud spinning noise. like it's not catching anything..
kinda hard to diagnose the noise from you just explaining it but is the starter mating with the flywheel? im not too sure what other "spinning noise" your talking about
ok so it was the cam shaft gear that needed to be replaced and so i did. now i have 2 bad injectors. does anyone have a diagram or instructions on how to change them?
p.s. thanks for all the suggestions and help guys!!
just unplug them, disconnect the fuel line and rail then pull them out. i highly recommend changing the seals when you put the new ones in. if you dont already have a haynes manual or something of the sort get one itll explain a lot
could possibly be a bad ECM driver... however could you have replaced one bad injector with another? were they used injectors? try moving a working injector to one of the not working ports, if it dont work, check for a short in the injector wire with an ohm meter. if that dont work haul it to a garage for a diagnostic.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.