yep its me again lol
after a non satisfactory result of swaping an EX harness in my sedan i went back to the yunk yard and got a stock DX harness engine/underdash. so i swapped them in again. modified the DX engine harness with the Si one i had for dizzy and injectors. ran the C1, C2, A3, A7 from the ECU. matched all my wires double checked everything and when i was ready to start it my ECU went bad i had check engine light on theres was no spark and the ecu wouldnt blink when i opened the switch. so i grabbed an extra PR4 from my DA and tried it on i know i wont work on the car just wanted to make sure it was the ECU and not the wiring and i was right it was the ECU.. When i plugged PR4 it was throwing code 4 and 10 i dunno if its bcuz of the ECU or bcuz my wiring is messed up lol. today i will try to get a PM6 and see whats up anyhow i also have a couple of plugs on the SI manifold that i dunno if i can wire them from the DX i took some pics one is attached to the monifold on the left side when i had the Si harness on it had a plug for it but on the DX im not sure. and the other one hangs on the back of the manifold its a rectangular plug with 2 wires going to it any help would be appreciated
after a non satisfactory result of swaping an EX harness in my sedan i went back to the yunk yard and got a stock DX harness engine/underdash. so i swapped them in again. modified the DX engine harness with the Si one i had for dizzy and injectors. ran the C1, C2, A3, A7 from the ECU. matched all my wires double checked everything and when i was ready to start it my ECU went bad i had check engine light on theres was no spark and the ecu wouldnt blink when i opened the switch. so i grabbed an extra PR4 from my DA and tried it on i know i wont work on the car just wanted to make sure it was the ECU and not the wiring and i was right it was the ECU.. When i plugged PR4 it was throwing code 4 and 10 i dunno if its bcuz of the ECU or bcuz my wiring is messed up lol. today i will try to get a PM6 and see whats up anyhow i also have a couple of plugs on the SI manifold that i dunno if i can wire them from the DX i took some pics one is attached to the monifold on the left side when i had the Si harness on it had a plug for it but on the DX im not sure. and the other one hangs on the back of the manifold its a rectangular plug with 2 wires going to it any help would be appreciated