Andrew
Active Member
Hey guys. I just got my z6 up and running in my rex, but when I took it out for a drive, it wouldn't drive past 3500rpms, much like ExclusiveImport's post.
Drive is emphasized b/c it has no problems reving up past 3500 while in nuetral. Only when it's in gear, i.e. driving.
I was throwing a couple codes, but after checking over my dizzy wiring(and finding/fixing one loose pin in one connecter), they all went away.... I don't get it.
I'm going to replace the IACV tomorrow (one of the codes thrown), just to get that out of the way. I'm going to drive it tomorrow morning and see if it's still happening, as I have yet to test it since the codes stopped blinking at me.
Current setup:
d16z6
boomslang ecu harness
virgin p28 ecu
re-soldered dizzy adapter wires
z6 dizzy
Anybody know whats up?
Thanks
-Andrew
Drive is emphasized b/c it has no problems reving up past 3500 while in nuetral. Only when it's in gear, i.e. driving.
I was throwing a couple codes, but after checking over my dizzy wiring(and finding/fixing one loose pin in one connecter), they all went away.... I don't get it.
I'm going to replace the IACV tomorrow (one of the codes thrown), just to get that out of the way. I'm going to drive it tomorrow morning and see if it's still happening, as I have yet to test it since the codes stopped blinking at me.
Current setup:
d16z6
boomslang ecu harness
virgin p28 ecu
re-soldered dizzy adapter wires
z6 dizzy
Anybody know whats up?
Thanks
-Andrew