98civicproject
New Member
whats up everyone.
I'm getting close to swapping the motor here in the next month or so, just need head work done and were ready to roll. I've included pics of car and random stuff. motor is an hr away, no pics of motor yet. But heres my layout.
I have a GSR bored to 84mm, Darton Sleeves, JE pistons 9:1, Eagle rods, Eagle Crank, balanced, Crower cams, Crower dual springs and ti retainers, ARP head studs, Cometic gaskets and seal replacement (head gasket incuded),
coming soon after motor is swapped and properly broke in.
Garret turbo maybe gt3076r, edelbrock intake, hondata tune, paint job maybe Si Blue, upgraded fuel system RC injectors walbro fuel pump. too much to list.
Side view 2dr ex coupe 1998
empty bay
inside, pretty clean
inside empty center console but heres what goes in there. next pic
shift boot and dvd screen needs cleaned up or refinished
new gsr linkage in place and ready to go
gsr intake manifold
p72 ecu and new wiring harness from Rywire
another view of harness from Rywire
ARP head studs
Crower dual spring and ti reatainer
Crower turbo cams ( arrived today)
Just waiting on the gaskets then I'll run to the shop and give my machinist everything he needs to finish up. I will get pics of the motor trust me, in a couple of days
I'm getting close to swapping the motor here in the next month or so, just need head work done and were ready to roll. I've included pics of car and random stuff. motor is an hr away, no pics of motor yet. But heres my layout.
I have a GSR bored to 84mm, Darton Sleeves, JE pistons 9:1, Eagle rods, Eagle Crank, balanced, Crower cams, Crower dual springs and ti retainers, ARP head studs, Cometic gaskets and seal replacement (head gasket incuded),
coming soon after motor is swapped and properly broke in.
Garret turbo maybe gt3076r, edelbrock intake, hondata tune, paint job maybe Si Blue, upgraded fuel system RC injectors walbro fuel pump. too much to list.
Side view 2dr ex coupe 1998
empty bay
inside, pretty clean
inside empty center console but heres what goes in there. next pic
shift boot and dvd screen needs cleaned up or refinished
new gsr linkage in place and ready to go
gsr intake manifold
p72 ecu and new wiring harness from Rywire
another view of harness from Rywire
ARP head studs
Crower dual spring and ti reatainer
Crower turbo cams ( arrived today)
Just waiting on the gaskets then I'll run to the shop and give my machinist everything he needs to finish up. I will get pics of the motor trust me, in a couple of days