mrnice1058
Senior Member
OK i had the engine started and it was working OK i needed to tune it but i didn't have it complete i needed to put the axles on and that was it, this is what i did after the last time i started
i put in the axles and the intermediate shaft
i had to make room for the alternator so i used a pry bar and bend the fender area about an inch i don't know if it moved my tranny or what
i put the wheel on and now it doesn't start it sounds like a car that is already started and you turn the key while it engine is on and it grins the fly wheel here is where i am stuck i took the starter off and checked the teeth on the starter and the flywheel and it was fine but why doesn't it start it wants to start but something is stopping it, it starts to want to start then stops because of that grinding noise when i took the starter out i had my dad turn the key and it turned while it was out so i was wondering if i put pressure on the engine and pushed the axle to tight in the tranny or if the tranny is really pushed in and i have to unbolt it and re-bolt it please guys help me out i am getting tired of working on this engine thanks guys
by the way the axles move with no problem and there is no noise or an locking problem.
i put in the axles and the intermediate shaft
i had to make room for the alternator so i used a pry bar and bend the fender area about an inch i don't know if it moved my tranny or what
i put the wheel on and now it doesn't start it sounds like a car that is already started and you turn the key while it engine is on and it grins the fly wheel here is where i am stuck i took the starter off and checked the teeth on the starter and the flywheel and it was fine but why doesn't it start it wants to start but something is stopping it, it starts to want to start then stops because of that grinding noise when i took the starter out i had my dad turn the key and it turned while it was out so i was wondering if i put pressure on the engine and pushed the axle to tight in the tranny or if the tranny is really pushed in and i have to unbolt it and re-bolt it please guys help me out i am getting tired of working on this engine thanks guys
by the way the axles move with no problem and there is no noise or an locking problem.