i recently dropped a zc(d16z6) in a 93 coupe dx
when i tried to crank the motor it does not turn over or clicks at all
i tried the battery and grounds(starter and dizzy were good last time i tested going test them again)
i am using the intake manifold off of a d15b7 didn't think it made a diiference
the d15b7 intake manifold does not have a map sensor on it
the d16z6 intake manifold does
also on my wire harness i don't have a plug for the map sensor but i already have a map sensor on my car on the fire wall is this odd?
my questions:
1. does it matter what intake manifold i use?
2. am i supposed to have 2 map sensors(firewall map is square, other is more rounded off)?
3. if so, am i supposed to wire it up myself?
4. can anyone help with advice on why my car says nothing when i try to crank it not even a check engine light
please help with any advice my car has been sitting up since november i really want to put her back on the road.....
thanks for any input
when i tried to crank the motor it does not turn over or clicks at all
i tried the battery and grounds(starter and dizzy were good last time i tested going test them again)
i am using the intake manifold off of a d15b7 didn't think it made a diiference
the d15b7 intake manifold does not have a map sensor on it
the d16z6 intake manifold does
also on my wire harness i don't have a plug for the map sensor but i already have a map sensor on my car on the fire wall is this odd?
my questions:
1. does it matter what intake manifold i use?
2. am i supposed to have 2 map sensors(firewall map is square, other is more rounded off)?
3. if so, am i supposed to wire it up myself?
4. can anyone help with advice on why my car says nothing when i try to crank it not even a check engine light
please help with any advice my car has been sitting up since november i really want to put her back on the road.....
thanks for any input