Recent content by prettylewtm

  1. P

    Need help hotwiring my car

    wait wait wait, scratch that. lol. i looked at my diagram again splice wht/red , wht/blk, and blu/wht together, then splice wht, blk/yel, and yel, together, this makes it like the key is in position II. now touch the black and white to a 12V source like the white wire. this will crank the car...
  2. P

    p72 ECU, has blown Q31 transistor.

    nevermind i think i figured it out, its just the purge output signal. well i dont have EVAP anymore so who cares!! lol
  3. P

    p72 ECU, has blown Q31 transistor.

    ok what does this transistor do? i bought the ECU guy said it was chipped. and it is. i opened it up after i bought it. and i also found a blown transistor at q31 on the board. does anyone know what this transistor controls? also cant i just replace it with another one from like radio shack or...
  4. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    well they definitely look new. i installed them and drove like 1000 feet down the street and came back. lol. so yea theyre new.
  5. P

    My B16 Rex

  6. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    yea theres PLENTY of junkyards nearby. i COULD sell the axles i have now but seriously. how much can i REALLY get for them? lol
  7. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    i would if i had the cash, but i cant afford those right now.
  8. P

    1988 crx seat swap from integra or ?

    your a tool. go read another import tuner magazine and have a nice day. just to let u know. i HEAR that ek seats will bolt up if you make a couple of the holes longer, only one that wont line up at all is the front one near the center console. you could just drill through the floor and use a...
  9. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    well hasport told me to take off the axle nuts while the car is on the ground and push the axle in. it should stop within a quarter inch of where the nut seats on (hub) well the passenger side 90-93 axle is fine but the other side using the 86-89 axle is too long. so i need the 90-93...
  10. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    i had a raptor 660!!!! torque for days! lol
  11. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    i bought the car without the motor installed . i did the swap myself. and i traded for my yamaha raptor.
  12. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    i think im just gonna get a 86-89 axle for the passenger side too, its a lil shorter.
  13. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    hows that going to make a difference? does the ring grind on the control arm or somethin?
  14. P

    just got done with my b16 swap, bad shaking in 2nd gear and above. under load?

    the axle on the passenger side has an ABS ring on it. do i need to knock that off of there? no the tranny isnt LSD as far as i kno
Back
Top