Search results for query: *

I did a JDM ITR rear disk swap a while ago (project car). Had the whole thing powder coated, polys installed and assembly. Much to my stupidity and surprise the lug pattern is 114.3 x 4. I need a 100 X 4. It was suggested that I try a GRS hub. I ordered one and it came with th ABS gear, twice...

I have a friend with limited budget needs an engine. Would like to get a jdm d15 he has a d15b7 now and whats direct bolt in. Do any of you know the similarities? Thanks in advance.

Okay the build is done short a few odds and ends. Spec's: B18C1 Block has ported oil galleries. ITR lost motion devices. Itr Ported oil pump. Golden Eagle Sleeves 9.75:1 Roller wave Pistons Stock Cam Carbon Fiber intake manifold. .5 oversized Black Nitrided Stainless Steel Valves. Endyn...

I have been looking for a high capacity fuel and oil filters. AEM was about the only source for fuel filters. They rate it to 500HP. I Could not find any flow capacities on it. The engine that I am putting together is easily capable of over 500 hp. I stumbled across CM filters. Construction...

I was at one of my customers today and they were fine tuning a gage. I have designed many gages but never with a tolerance of 0.0005mm or 20 millionths of an inch. Common tolerances are 1 or 2 microns. this gage was increadable but I do not believe it can be done without enviroment control and...

I bought a new fuel pump from Endyn, a Bosch unit. It is considerably bigger (size and flow) over a stock pump. The stock pump also had 5/16 pick up lines. The Bosch has 3/8's. I did not want a restriction so I came up with this...... I retained the lower rubber grommet and the rubber...

I bought a rear disk swap on ebay. Had it powder coated, poly bushings and installed. When I went to put on the rim the lug pattern is off. I need a 4 x 100 and its a 4 x 114.3. The car is a 95 del Sol. The swap said JDM rear conversion. So a new hub is needed. Which one do I get? Integra or...