ok might be a dumb ? but once again obd wise on the same car... i bought a b16a obd1 engine and tranny i want to put it in my ek so far i have all the mount (not sure on the tranny mount... anyways what jumper do i use if im going obd2b to obd1? and what harness do i use? im lost cuz i have a y7...
ok i have a 00 civic si and im having problems with the car when i drive the car all of a sudden it shakes like the axle is broken or makes it stop i checked the boots and they r not ripped ... now i picked up the car and had it in neutral and i turned the tire and it locked into place back and...
dose anybody know the process? i been working on this motor keeping it obd2 now i think i just need the swap the oil pump to make the motor turn on this way i can add the crank sensor.
ok well i was wondering something about my car what is the best ecu to run with a jdm b16a right now my car will red line around 8600-8800 i have a p2t ecu not sure if i could have a better one that will help me accelerate faster because its not as fast as some other si's i have seen.
hey everybody i have a em1 and ive had it for a while now but im not sure what i have been noticing... when i take off sometimes my car seems to like shake.. it seems like it is (wheel hopping) but it only dose it on first gear sometimes...and its not wheel hopping just seems like it is what...
ok friend has a d16y7 in a 97 civic ek (auto) wants to do swap what will be needed?
some 1 locally is selling the motor auto trans ecu wire harness with the swamp for 400... so what will i need to complete the swap i know i need axle i dont believe my old ones work... so what else? i believe...
ok i have both motors out side by side the motor would not start when i did the swap so i took it out again this time adding the crank sensor but on my 95 ex motor d16z6 it dose not have the bolts for the sensor nor the thing bolt hole for the crank sensor now look at the pics below my y8 block...
ok i have a 99 ex and i have and i had a y8 in it now i put a z6 and i am using the z6 trans mission now my problem is mounting it on the car i can get the driver and rear mount on the car on but the transmission mount is like pushed froward about 2 inches or so i cant mount it tried messing...
ok i have a d16y8 vtec with a blown motor... now i have took it out and have been swapping out with a d16z6 single vtec i want to keep it obd2 but what do i need to do? so far i have swapped out the alternator power steering pump slave cylinder because it was mission it and that motor bracket...
ok here is whats up i have a d16y8 with a blown motor on a 99 ek i bought a z6 and now im having probelms thinking of how im going to wire it up?? i didnt realize the dizzy was diffrent from the y8 block ( i forgot it was also obd1....) so ive been swapping out my y8 stuff to my new z6 motor...
hi im new but i have a very bad problem i dont know whats wrong with my gfs honda accord its a 91 ex i did a motor swap from a f22a1 to the same thing beacause her engine rod bent... well now i got the new motor in it but when i start up the car it idls and it goes very fast till it starts...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.