ceehris
New Member
this is directed towards pissedoffsol's 1wire to 4wire oxygen sensor thread.
I have wired up a 4 wire o2 sensor with my obd0 to obd1 conversion
and I keep getting a CEL 41. my question is will this happen if I get the black wires (heater circuit) mixed up? because in his post it says it will stall when warm within 10-30 seconds if you get them mixed up but I have not had a stall yet. I wondering do I just need to swap the black wires because I have measured the resistance across the o2 sensor black wires and it is 15 ohms which is within range.....
I would appreciate anyones feedback....
I have wired up a 4 wire o2 sensor with my obd0 to obd1 conversion
and I keep getting a CEL 41. my question is will this happen if I get the black wires (heater circuit) mixed up? because in his post it says it will stall when warm within 10-30 seconds if you get them mixed up but I have not had a stall yet. I wondering do I just need to swap the black wires because I have measured the resistance across the o2 sensor black wires and it is 15 ohms which is within range.....
I would appreciate anyones feedback....
Last edited: