im doing a b16a vtec swap in a 88 crx si the thing im stuck on is, on the driver side of the engine the wiring harness that runs to the resistor box has the small two pin plug that hooks to the resistor, but the bigger round 10 pin connector, what is it for?
i compared it to my buddies crx si and his plugs into a mateing connector. my connector that this is supose to mate with ony has 8 wires and is square.
do i need this and if so what do i do
i compared it to my buddies crx si and his plugs into a mateing connector. my connector that this is supose to mate with ony has 8 wires and is square.
do i need this and if so what do i do
Last edited: