from start to were i am now, it took me about 2 hours of straight work; in my garage on 2 jack stands. lol
Tranny is completely unbolted and i have 2-3" (on top, maybe an 1/8th of an inch on the bottom) of room (i dont think thats going to cut it)- but is getting stuck. Between the shaft, and one of the upper tranny mount bolts, i cant get this thing to move enough to give me my clearance i need for the alignment tool
I've also run out of jacks stands, so i cannot place one under the motor and remove a mount or 2.
Is there any way to get the clearance i need to do this clutch?
Thanks
Bill
Tranny is completely unbolted and i have 2-3" (on top, maybe an 1/8th of an inch on the bottom) of room (i dont think thats going to cut it)- but is getting stuck. Between the shaft, and one of the upper tranny mount bolts, i cant get this thing to move enough to give me my clearance i need for the alignment tool
I've also run out of jacks stands, so i cannot place one under the motor and remove a mount or 2.
Is there any way to get the clearance i need to do this clutch?
Thanks
Bill