b18a1 runs better than b18b1 why?

We may earn a small commission from affiliate links and paid advertisements. Terms

my 92 teg blew a rod bearing so i found a 94 motor to put in while i rebuild the b18a1 but this b1 motor doesn't have anywhere near the power the a1 did any suggestions?
 
Could be a numer of things. Have you checked the compression? Running it on the proper ECU? Everything wired correctly? These motors are different OBDs, which I am sure you know already if it is even running.

All four cylinders are firing, no missing, smoke, CELs? Any other clues?
 
As a general rule of thumb, always use the ecu that comes with the corresponding engine from the factory.

PGMFI.org has info you may want to read about compatibility, as some ecus will run multiple motors fine.
 
Back
Top