b18a1 swap

We may earn a small commission from affiliate links and paid advertisements. Terms

1gEF-8

Junior Member
just finished a ls swap. wanted to make sure obd0 pr4 is direct plug in to a 91 crx si. do i need to change any pins??
 
Originally posted by brian11to1@May 12 2005, 01:30 PM
if you just finised the swap why are you asking? i dont think there are any plug changes...
[post=498441]Quoted post[/post]​

just finished installing the engine. just making sure there are no ecu pin changes that all.
 
thats what i thought. I wasnt too sure. but, im pretty sure since the car is an Si there arent any wiring changes to be made.
 
Originally posted by brian11to1@May 12 2005, 01:30 PM
if you just finised the swap why are you asking? i dont think there are any plug changes...
[post=498441]Quoted post[/post]​


Was your comment 100% needed?

Stop being an E hardass.


And to answer the question, you do not need to make any changes. If the car is an Si, it's already wired for multipoint. It's a non-vtec motor, so you don't have to worry about that. Everything is just plug-and-play. You sholdn't have to do ANYTHING to any of the wiring inside the car, other than unplugging your old ECU and plugging in your new one.
 
Back
Top