car runs but in limp mode h22 swap

[actionisgo]

hello just got engine in 93 del sol and wired runs but doesnt rev up, im using p28 auto computer from 93 delsol,and now have a h22 5spd, wont rev up. what should i look for? computer no good? any help would be great,thanks.

 

[actionisgo]

would the auto tranny p28 computer give me problems should i go to a 5 sped ecu?

 

[posol]

it will give you a problem, but not like the one you are experiencing...

you can modify an auto ecu to become a manual. https://hondaswap.com/~pills has a write up on it

if you're topping out at 3500 rpms, you have a "Critical error"
pull your codes
re-check your wiring

 

[actionisgo]

i pulled the codes, i got a 4, crank position sensor, 1 long then 9 quick so a 19, auto tranny lock up control valve, 1 long , so 10, i have a 98 h22 anyone have a diagram of crank sensor,to see if it wired correct or could tell me how, the auto tranny code, will that cause this? the ten code, intake sensor could i have the 2 mixed up? any help would be super.sam

 

[actionisgo]

i finally figured it all out!! the crank sensor when the wires were taped they touched each other! now it runs a1, i was wondering should i get a chipped computer now, do they make a big difference?