well i got everything all installed. And ready to start up. Everything seems to be within spec. ACL is the ISH! But the crank is so hard to turn with everything properly in place. It has been torque down properly. Bolted two screws in the crank (flywheel side) and tried turning it by hand. It would not move. So i used a handle of the handle and tried slightly to turn it. The crank turns but it seems like something is making the crank not spin freely. I believe its the thrust washer because when i tried turning the crank. Half the thrust washer came out. I mean I know i installed it right. Because the Groove side suppose to face outward right? Is it because it is lacking oil and theres some friction? I mean I lube everything up before the final install. Help?