I bought a new fuel pump from Endyn, a Bosch unit. It is considerably bigger (size and flow) over a stock pump. The stock pump also had 5/16 pick up lines. The Bosch has 3/8's. I did not want a restriction so I came up with this......
I retained the lower rubber grommet and the rubber bumper mounting that the original pump used. This is to isolate any vibration.
I also ground off the top fuel line connector. That was a major pain in the butt.. then removed the electrical connector.
Bought a few plumbing pieces, asked one of my customers to make the Aluminum adapter. and assembled it. The 3/8 tubing is not set in these pics I need a tube bender...
I retained the lower rubber grommet and the rubber bumper mounting that the original pump used. This is to isolate any vibration.
I also ground off the top fuel line connector. That was a major pain in the butt.. then removed the electrical connector.
Bought a few plumbing pieces, asked one of my customers to make the Aluminum adapter. and assembled it. The 3/8 tubing is not set in these pics I need a tube bender...