Do I need a the injector resistor box??

[Som1Dies2Nite]

Engine15B2
Head:Z6
ECU28
Injectors used are saturated 10 ohm.
Do I need the resistor box? I dont see one on a 92-95 engine diagram with the P28 ecu. I am using the redpepperracing diagrams and are not that clear.

 

[Slo86GT]

If you are using the 92+ injectors civic, no, if you are using the 88-91 Civic, 86-93 teggy, or any 'lude injectors, yes.

I don't know the specifics of what ohm level is high or low impedence, etc, but those are the yearly qualifications. You have to match ECU to injector style, basically.

 

[phyregod]

Saturated Injectors = NO resister box.

 

[Som1Dies2Nite]

Originally posted by phyregod@Aug 2 2005, 10:19 AM
Saturated Injectors = NO resister box.

[post=534412]Quoted post[/post]​

Should I use the peak/hold type injectors since I already have the resistor box and the plus side is that peak/hold are suppose to respond quiker? Let me know.

 

[phyregod]

If you have a set of peak and hold, use them! They are better.

Its pretty much the same difference on a stockish motor, though. Saturated will get the job done just fine.

 

[Som1Dies2Nite]

Originally posted by phyregod@Aug 2 2005, 12:30 PM
If you have a set of peak and hold, use them! They are better.

Its pretty much the same difference on a stockish motor, though. Saturated will get the job done just fine.

[post=534530]Quoted post[/post]​

I will go ahead and keep the satuarated inj. So where would the injector wires run if they dont need the resistor box.