Ok, I open the box and take out the flywheel, and immediately something doesn't look right.
Put the pressure plate up to it, and sure enough...
The flywheel doesn't have the little nubbies for the smaller holes in the pressure plate. There ARE three larger nubbies, that are evenly spaced between the threaded bolt holes, but they don't fit in the smaller holes, and aren't remotely close to anything...they don't interfere with the pressure plate sitting flush on the flywheel...
But shouldn't it have the nubbies to make sure the pressure plate is 100% centered?
Also, the fucking hole in the middle is too goddamn big for the bearing that came with the Exedy clutch...
What the fuck? Anyone know what to do?
Oh, and here's a pic of my blingedy blingin' Skunk2 test pipe, just for good measure...
Put the pressure plate up to it, and sure enough...
The flywheel doesn't have the little nubbies for the smaller holes in the pressure plate. There ARE three larger nubbies, that are evenly spaced between the threaded bolt holes, but they don't fit in the smaller holes, and aren't remotely close to anything...they don't interfere with the pressure plate sitting flush on the flywheel...
But shouldn't it have the nubbies to make sure the pressure plate is 100% centered?
Also, the fucking hole in the middle is too goddamn big for the bearing that came with the Exedy clutch...
What the fuck? Anyone know what to do?
Oh, and here's a pic of my blingedy blingin' Skunk2 test pipe, just for good measure...