n00b-racer07
New Member
Okay so,
with the catback exhaust systems, and specifically for a d16 motor.
Most of the headers I see are around the 2.25 OD range on the bottom and 2.0 ID.
If I were to purchase a catback with say, a 2.5 OD and try to bolt it onto the headers is this going to work, or am I out of luck. I'm asking because I want to by products from two different makers and am concerned about how they are going to bolt on togeather.
Will the gaskets take care of this problem at all assuming the bolts go togeather okay?
I would assume that if you purchased aftermarket pieces that they would all be, in a general sense, the same. excluding quality and such of different sellers.
with that,
any suggestions on ones that you know have worked without a hitch?
thanks,
the n00b
with the catback exhaust systems, and specifically for a d16 motor.
Most of the headers I see are around the 2.25 OD range on the bottom and 2.0 ID.
If I were to purchase a catback with say, a 2.5 OD and try to bolt it onto the headers is this going to work, or am I out of luck. I'm asking because I want to by products from two different makers and am concerned about how they are going to bolt on togeather.
Will the gaskets take care of this problem at all assuming the bolts go togeather okay?
I would assume that if you purchased aftermarket pieces that they would all be, in a general sense, the same. excluding quality and such of different sellers.
with that,
any suggestions on ones that you know have worked without a hitch?
thanks,
the n00b