I just got my d16z6 today for my 90 crx si. Ran into a little bit of a problem. The wiring harness doesn't plug in to the connectors near the fuse box. I'm planning on ghetto rigging the vtec using a fields afc vtec controller, a auto relay, and a rpm switch, but how do i plug the wiring harness into my ecu??? the plugs don't match!!! i'm confused. I could really use the help, i can't find it anywhere.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Got my motor!!!
- Thread starter RFHOMI2U
- Start date
- Replies 1
- Views 708
We may earn a small commission from affiliate links and paid advertisements. Terms
Hope this helps
Wiring diagram for MSD rpm switch part #PN8950 and an MSD module selector part # PN8670 with 30 amp 4 wire automtive relay:
Red Wire-------------------------12 V source
Black Wire-----------------------( - ) Ground
White Wire----------------------( - ) Side of the ignition coil ; splice or conect to ECU pin B15 or B17
Yellow Wire---------------------# 86 on the relay ; you have to cut the two loop wires
30 amp relay
#85 ------12 V source
#86-------Yellow wire form the rpm switch
#30-------12 V source
#87-------Vtec solenoid (green and yellow wire)
#87a-------Not used
Field SFC vtec controller for 88-91 crx application : vtec controller ECU pin location
Red wire--------splice/connect to A15 (yellow/black)
Green Wire-----splice/connect to B15 (white)
Dark Blue-------to vtec solenoid
Yellow-----------not used
White/green---not used
Purple-----------cut/connect to B16 ecu side (white/red)
Light Blue------cut/connect to B16 engine side (white/red)
Orange---------cut/connect to C11 ecu side (white)
Brown----------cut/connect to C11 Engine side
Black-----------( - ) ground
Wiring diagram for MSD rpm switch part #PN8950 and an MSD module selector part # PN8670 with 30 amp 4 wire automtive relay:
Red Wire-------------------------12 V source
Black Wire-----------------------( - ) Ground
White Wire----------------------( - ) Side of the ignition coil ; splice or conect to ECU pin B15 or B17
Yellow Wire---------------------# 86 on the relay ; you have to cut the two loop wires
30 amp relay
#85 ------12 V source
#86-------Yellow wire form the rpm switch
#30-------12 V source
#87-------Vtec solenoid (green and yellow wire)
#87a-------Not used
Field SFC vtec controller for 88-91 crx application : vtec controller ECU pin location
Red wire--------splice/connect to A15 (yellow/black)
Green Wire-----splice/connect to B15 (white)
Dark Blue-------to vtec solenoid
Yellow-----------not used
White/green---not used
Purple-----------cut/connect to B16 ecu side (white/red)
Light Blue------cut/connect to B16 engine side (white/red)
Orange---------cut/connect to C11 ecu side (white)
Brown----------cut/connect to C11 Engine side
Black-----------( - ) ground