got my motor together and it runs rough when i first start it up but after about a minute it smooths out. it also has no power when taking off. i have to ride the clutch or it will die. i just re ringed it and put rod bearings in it. any help????
got my motor together and it runs rough when i first start it up but after about a minute it smooths out. it also has no power when taking off. i have to ride the clutch or it will die. i just re ringed it and put rod bearings in it. any help????
yea i took it on a backroad and went from 20-50 in third gear probly about 20 times. it only has 150 miles on it so far. and its coming out of it a little at a time.
yea i took it on a backroad and went from 20-50 in third gear probly about 20 times. it only has 150 miles on it so far. and its coming out of it a little at a time.
you wernt beating on it where you? I wouldn't take a freshly rebuilt motor over 3500rpm for at least a 1000 miles until you know the pistons are properly seated
you wernt beating on it where you? I wouldn't take a freshly rebuilt motor over 3500rpm for at least a 1000 miles until you know the pistons are properly seated
I usaully go with a power steering bolt hole, and take out the starter and use the top starter bolt hole, seems to bring it out steady and dosent dig into anything.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.