My Nissan can't make it up the driveway with out using planks of 2x6, I needed something that was easy to lay down long enough to get the car out of the garage, then remove them til I get back. pictured is only one set, I made two of them. I haven't tested it yet, but I'm hoping this is long enough to allow my car to make it up, last time I used 2x6s I ran the boards all the way up the apron, however those boards were flat and didn't make up for any low spots where this new setup does.
we'll see when I get around to testing them...
I put two handles on each end so to move them I just fold them in half and grab it with one hand.
Idea is to store them in my shed, and when the Nissan is out I'll put them in the garage, when I put it back up I'll put them back in the shed.
total cost was around $15.00
we'll see when I get around to testing them...
I put two handles on each end so to move them I just fold them in half and grab it with one hand.
Idea is to store them in my shed, and when the Nissan is out I'll put them in the garage, when I put it back up I'll put them back in the shed.
total cost was around $15.00