I am looking into purchasing a car. The car has a B20b/b16 motor. I was wondering what you guys thought of this setup. Done right?
BLOCK
B20B block 84mm
RS machine 84mm pistons (11.5:1)
stock PR4 rods (resized) with ARP rod bolts
Stock sleeves
PR4 crank (micropolished)
Top line bearings
oem head gasket
ITR oil pump
ITR water pump
passwordjdm magnetic drain plug
oem oil filter
all new OEM gaskets
HEAD
PR3 B16 head (resurfaced)
new valve seals
3 angle valve job
intake & exhaust ports have been cleaned up
Rocket motorsports valve springs and Ti retainers
Skunk2 pro series Pro1+ cams
BOLT-ONS
AEBS intake manifold
obd1 gsr throttle body 65mm bored out by maxbore.com
DC intake arm with blox velocity stack with blox filter
hondata intake manifold gasket
Hy-tech replica race header
k-teller 2.5" SS piping, no cat or resonators
2.5' SS magnaflow oval muffler
STR fuel rail with braided fuel line feed
B&M fuel regualtor and guage on top of rail
Walbro 255 fuel pump
full-race ls/vtec oil line kit
Allstar breather catch can
new oem ITR ignition wires
NGK plugs
new oem cap and rotor
STR cam gears
King motorsports extended intake & exhuast studs
Fluidyne radiator
Samco hoses (red)
slim line fan
Mugen fan switch
Mugen thermostat
new oem fuel filter
Innovative race billet mounts
new oem clutch line
new oem speedometer cable
new oem ITR valve cover with ITR crome oil cap
Odyssey PC680 battery with odyssey battery box holder
Thanks for the advice guys. It means a lot.
BLOCK
B20B block 84mm
RS machine 84mm pistons (11.5:1)
stock PR4 rods (resized) with ARP rod bolts
Stock sleeves
PR4 crank (micropolished)
Top line bearings
oem head gasket
ITR oil pump
ITR water pump
passwordjdm magnetic drain plug
oem oil filter
all new OEM gaskets
HEAD
PR3 B16 head (resurfaced)
new valve seals
3 angle valve job
intake & exhaust ports have been cleaned up
Rocket motorsports valve springs and Ti retainers
Skunk2 pro series Pro1+ cams
BOLT-ONS
AEBS intake manifold
obd1 gsr throttle body 65mm bored out by maxbore.com
DC intake arm with blox velocity stack with blox filter
hondata intake manifold gasket
Hy-tech replica race header
k-teller 2.5" SS piping, no cat or resonators
2.5' SS magnaflow oval muffler
STR fuel rail with braided fuel line feed
B&M fuel regualtor and guage on top of rail
Walbro 255 fuel pump
full-race ls/vtec oil line kit
Allstar breather catch can
new oem ITR ignition wires
NGK plugs
new oem cap and rotor
STR cam gears
King motorsports extended intake & exhuast studs
Fluidyne radiator
Samco hoses (red)
slim line fan
Mugen fan switch
Mugen thermostat
new oem fuel filter
Innovative race billet mounts
new oem clutch line
new oem speedometer cable
new oem ITR valve cover with ITR crome oil cap
Odyssey PC680 battery with odyssey battery box holder
Thanks for the advice guys. It means a lot.
Last edited: