How do you run wires from engine bay to interior? Do you need to drill a hole through firewall? i am trying to run my neon wires to the interior but i couldn't find any hole to put wires through. Thanks
There are some rubber grommets that you can poke a hole in, and send wires through safely, without worrying about fraying them. This really does belong in the Ice and Rice forums.
i looked for the rubber grommets but i couldn't find any grommet that close to the ( brake pedal or floor ). i found one grommet, but it's to far on top ( next to the right hand windshield wiper) and that is hard to get the hold of the wires from the inside
Originally posted by redwidow@Dec 3 2003, 02:10 AM hey, thanks for all yours help. the only gromet i found on my 00 prelude is on the driver side next to the windshield wiper
like i said before.. drill a hole from the inside to the engine bay. make sure you dont drill into anything. and put a grommet in there.
if you drill a half inch hole, use a half inch grommet.. etc. the grommet will ensure you that nothing will short out later on, and will make the install look clean, almost stock.. good luck...post up pics when your done.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.