just checking interest on the following.
pending sale of just the shell of the car i may be parting out my ls/vtec.
jdm b16 sir II head (obd1) - mild port work on the head by Unleaded Racing , 3 angle grind on all valves
itr inner valve springs
itr retainers
ctr outer valve springs
ctr intake cam
skunk2 adjustable cam gears
ITR parts : throttle body , intake manifold (port matched) , exhaust cam
itr tranny 4.40 final drive
with 1995 integra LS fifth gear .714:1 and stock 5th gear included
RC 310 Injectors
AEM cold air intake
DC sports 4-1 ceramic header
b & m fuel pressure regulator and gauge
ITR Exedy Clutch and Pressure Plate (15k miles)
Hondata Intake Manifold Gasket
block b18a fresh bore pistons and rings less than 8000 miles ago:
pr3 .25 mm over pistons *81.25mm bore*
ARP rod bolts
ARP head studs
ls rods
hondata p28 ecu - stage 2 with datalogging and stage 4 software with romeditor included and pocket programmer included, stage 4 w/out the 3 step rev limiter basically...
just wondering if anyone may be interested in any of this... the shell selling sounds promising so just testing the waters.. pics of everything will be available if/when i pull motor
pending sale of just the shell of the car i may be parting out my ls/vtec.
jdm b16 sir II head (obd1) - mild port work on the head by Unleaded Racing , 3 angle grind on all valves
itr inner valve springs
itr retainers
ctr outer valve springs
ctr intake cam
skunk2 adjustable cam gears
ITR parts : throttle body , intake manifold (port matched) , exhaust cam
itr tranny 4.40 final drive
with 1995 integra LS fifth gear .714:1 and stock 5th gear included
RC 310 Injectors
AEM cold air intake
DC sports 4-1 ceramic header
b & m fuel pressure regulator and gauge
ITR Exedy Clutch and Pressure Plate (15k miles)
Hondata Intake Manifold Gasket
block b18a fresh bore pistons and rings less than 8000 miles ago:
pr3 .25 mm over pistons *81.25mm bore*
ARP rod bolts
ARP head studs
ls rods
hondata p28 ecu - stage 2 with datalogging and stage 4 software with romeditor included and pocket programmer included, stage 4 w/out the 3 step rev limiter basically...
just wondering if anyone may be interested in any of this... the shell selling sounds promising so just testing the waters.. pics of everything will be available if/when i pull motor