Ok once again im here with a lil issue with the sohc zc. I did the mini me swap on the zc a few months ago. And alls been good since until now. The other night my crank pulley flew off. Luckily it happend while i was sitting in traffic. Well the next morning after work i got a new pulley bolt and some locktite. Well i put the pulley back on and it was kinda loose on the crank. knowing it's not supposed to be loose I tried another pulley and it was also loose. After close examination of the crank it looked kinda spun (outta round).
Being I didn't have a new block lying around i just put alot of loc-tite on the bolt and key and torked it down to the specifics that came with the bolt. Well all was good until a day later.
Now after she warms up she throws a cel and starts reving up and down. And while driving when you switch gears the rpm's wont drop. I checked the codes and it thew a light 10 and 43 the iat and fuel system error. I replaced the iat and no good still the same. Now i have the integra ls ecu and the code 43 dont apply to the crx as i'm told. Now i know the pulley fallig off doesn't have anything to do with my current problem unless you guys know other wise.
if anyone can inlighten me on my reving problem I'd greatly appreciate it.
Oh yeah i did check for vacuum leaks and there were none.....
Being I didn't have a new block lying around i just put alot of loc-tite on the bolt and key and torked it down to the specifics that came with the bolt. Well all was good until a day later.
Now after she warms up she throws a cel and starts reving up and down. And while driving when you switch gears the rpm's wont drop. I checked the codes and it thew a light 10 and 43 the iat and fuel system error. I replaced the iat and no good still the same. Now i have the integra ls ecu and the code 43 dont apply to the crx as i'm told. Now i know the pulley fallig off doesn't have anything to do with my current problem unless you guys know other wise.
if anyone can inlighten me on my reving problem I'd greatly appreciate it.
Oh yeah i did check for vacuum leaks and there were none.....