wht92teg
Junior Member
hey guys i am new to this site, but have a general question... i am building a ls/vtec motor and ran into a situation
the engine that i bought for 150 bucks, has a froze #1 piston
now i know that i am going to have to bore the motor, so here is one of my questions
do i bore to say 84-84.5mm (1.8l to 2.0l) and use a block gaurd
or do i get the block sleeved?
also is anyone using a msd sci igniton? i am curious to the ignition as well due to the fact that i have researched and seen a "constant voltage supply" box which keeps voltage to the ign. box around 17v at all times. is that needed?
thanks in advance
the engine that i bought for 150 bucks, has a froze #1 piston
now i know that i am going to have to bore the motor, so here is one of my questions
do i bore to say 84-84.5mm (1.8l to 2.0l) and use a block gaurd
or do i get the block sleeved?
also is anyone using a msd sci igniton? i am curious to the ignition as well due to the fact that i have researched and seen a "constant voltage supply" box which keeps voltage to the ign. box around 17v at all times. is that needed?
thanks in advance